*) International Journal of Language and Literature is Accredited Sinta 4 by The Ministry for Research, Technology and Higher Education (RISTEKDIKTI)
Prospective authors are kindly invited to submit full text papers including results, tables, figures and references. All submitted articles should report original, previously unpublished research results, experimental or theoretical. Articles submitted to the IJLL should meet these criteria and must not be under consideration for publication elsewhere. Manuscripts should follow the style of the IJLL and are subject to both review and editing.
1. General Author Guidelines
All manuscripts must be submitted to IJLL Editorial Office using Online Submission at E-Journal portal address:
https://ejournal.undiksha.ac.id/index.php/IJLL/user/register where author register as Author by online.
2. Reviewing of manuscripts
Every submitted paper is independently reviewed by at least one peer-reviewers. The decision for publication, amendment, or rejection is based upon the reports/recommendation and made by Editor. If reviewer consider a manuscript unsuitable for publication in this journal, a statement explaining the basis for the decision will be sent to the authors within three months of the submission date.
3. Revision of manuscripts
Manuscripts sent back to the authors for revision should be returned to the editor without delay. Revised manuscripts can be sent to editorial office through the Online Submission Interface. The revised manuscripts returned later than three months will be considered as new submissions.
4. Guideline for Online Submission
Author should first register as Author and is offered as Reviewer through the following address:
The author should fulfill the form as detail as possible where the star marked form must be entered. After all form text box was filled, Author clicks on “Register” button to proceed the registration. Therefore, Author is brought to online author submission interface where Author should click on “New Submission”. In the Start a New Submission section, click on “’Click Here’: to go to step one of the five-step submission process”. The following are five steps in online submission process:
Step 1 - Starting the Submission: Select the appropriate section of the journal, i.e. Original Research Articles, Review Article, or Short Communication. Thus, the author must check-mark on the submission checklists. An author should type or copy-paste Covering Letter in Letter to Editor.
Step 2 – Uploading the Submission: To upload a manuscript to this journal, click Browse on the Upload submission file item and choose the manuscript document file (.doc/.docx) to be submitted, then click "Upload" button until the file has been uploaded. Do not upload cover letter and other supplementary files here.
Step 3 – Entering Submission’s Metadata: In this step, detail authors metadata should be entered including marked corresponding author. After that, manuscript title and abstract must be uploaded by copying the text and paste in the text box including keywords.
Step 4 – Uploading Supplementary Files: Supplementary file should be uploaded including Covering/Submission Letter, and Signed Copyright Transfer Agreement Form. Therefore, click on Browse button, choose the files, and then click on Upload button.
Step 5 – Confirming the Submission: Author should final check the uploaded manuscript documents in this step. To submit the manuscript to IJLL, click Finish Submission button after the documents are true. The corresponding author or the principal contact will receive an acknowledgment by email and will be able to view the submission’s progress through the editorial process by logging in to the journal web address site.
After this submission, Authors who submit the manuscript will get a confirmation email about the submission. Therefore, Authors are able to track their submission status at any time by logging in to the online submission interface. The submission tracking includes a status of manuscript review and editorial process.
5. Author Fee (No Page Charge)
IJLL is an open access journal. Authors should not pay any processing and submission fees for article processing (free of charge). Readers can read and download any full-text articles for free of charge.
6. User Rights
All articles published Open Access will be immediately and permanently free for everyone to read and download.
6. Manuscript Preparation Guidelines
6.1. General Organization of Paper
The paper will be published in IJLL after the peer-reviewed process and decided as “Accepted” by Editor. The final paper layout will be reproduced by Editorial Office of IJLL. The final paper layout in PDF type, known as “Uncorrected Proof” should be corrected by Author. The final corrected proof will be published first in “Article In Press” pre-issue.
Manuscript content should, in general, be organized in the following order: Title; Authors Name; Authors Affiliation; Authors Email; Abstract; Keywords; Introduction; Methods; Results and Discussion; Conclusions and Suggestions; and References.
6.2. Section Headings
Three levels of heading are allowed as follows:
- Level 1 (Heading1 format) - 11pt, Times New Roman bold, Title Case, Centre
- Level 2 (Heading2 format) - 11pt, Times New Roman, left justified
- Level 3 (Heading3 format) - 11pt, Times New Roman bold italic, left justified
6.3. Body Text
The body of the text is a set of body text paragraphs defined as follows:
- 11pt Times New Roman
- One space
- Spacing after the heading is 1
- Spacing before the new heading is 1
- Indentation for the first line is 1 cm
Bullet and numbering within body text are not allowed. All sentences should be typed as descriptive paragraph.
Tables are sequentially numbered with the table title and number above the table. Tables should be centered in the column OR on the page. Tables should be followed by a line space. Elements of a table should be single-spaced. However, double spacing can be used to show groupings of data or to separate parts within the table. Table headings should be in 11pt not bold. Tables are referred in the text by the table number, e.g., Table 1.
Figures are sequentially numbered commencing at 1 with the figure title and number below the figure as shown in Figure 1.
The equation should be prepared using MS Equation Editor (not in image format). The equation number is to be placed at the extreme right side.
6.8. Units, Abbreviations, and Symbols
Metric units are preferred and should be consistent throughout body text. Define abbreviations and symbols at the first time as they are introduced in the text.
6.9. Manuscript Heading, Font, and Spacing
The manuscript should be typed using word processors (Microsoft Word or Open Office) software. The font used throughout the paper is Times New Roman. The paper size is A4 (i.e., 210 x 297 mm), two-column format with a 2.5 cm margin at the top, a 2.5 cm margin at the bottom, 3.0 cm margin on the left, and 3.0 cm margin on the right. Lines are one spaced, justified. Page numbers should be included in the text located in the footer section of each page. Use of pronouns such as I, we, etc. is to be avoided.
Manuscript submitted to this journal should follow the heading below, except for the review article: Title; Authors Name; Authors Affiliation; Authors email; Abstract; Keywords; Introduction; Methods; Results and Discussion; Conclusions and Suggestions; and References.
6.10. Paper Title
This is your opportunity to attract the reader’s attention. Remember that readers are the potential authors who will cite your article. Identify the main issue of the paper. Begin with the subject of the paper. The title should be accurate, unambiguous, specific, and complete. Do not contain infrequently-used abbreviations.
The title of the paper should be in 14pt bold Times New Roman, capitalized, and be centered. The title should have 0 pts space above and below.
6.11. Authors Name, Affiliations, and Email
Write Author(s) names without a title and professional positions such as Prof, Dr, Production Manager, etc. Always give your First and Last names. Write clear affiliation of all Authors. Affiliation includes a name of department/unit, (faculty), a name of university, address, country. Please indicate Corresponding Author (include email address) by adding number in superscript behind the name.
Author names should be in 11pt Times New Roman. The body of the text should commence two lines (24 points) below the last address.
Present/permanent address. If an author has moved since the work described in the article was done, or was visiting at the time, a 'Present address' (or 'Permanent address') may be indicated as a footnote to that author's name. The address at which the author did the work must be retained as the main, affiliation address.
6.12. Abstract and Keywords
An abstract should stand alone, means that no citation in the abstract. Consider it the advertisement of your article. The abstract should tell the prospective reader what you did and highlight the key findings. Avoid using technical jargon and uncommon abbreviations. You must be accurate, brief, clear and specific. Use words which reflect the precise meaning. The abstract should be precise and honest. Please follow word limitations (100‐150 words).
Keywords are the labels of your manuscript and critical to correct indexing and searching. Therefore the keywords should represent the content and highlight of your article. Use only those abbreviations that are firmly established in the field. e.g. DNA. Each word/phrase in keyword should be separated by a comma (,).
In Introduction, Authors should state the objectives of the work at the end of introduction section. Before the objective, Authors should provide an adequate background, and very short literature survey in order to record the existing solutions/method, to show which is the best of previous researches, to show the main limitation of the previous researches, to show what do you hope to achieve (to solve the limitation), and to show the scientific merit or novelties of the paper. Avoid a detailed literature survey or a summary of the results. Do not describe literature survey as author by author, but should be presented as group per method or topic reviewed which refers to some literatures.
Example of novelty statement or the gap analysis statement in the end of Introduction section (after state of the art of previous research survey): “........ (short summary of background)....... A few researchers focused on ....... There have been limited studies concerned on ........ Therefore, this research intends to ................. The objectives of this research are .........”.
Methods should make readers be able to reproduce the experiment. Provide sufficient detail to allow the work to be reproduced. Methods already published should be indicated by a reference: only relevant modifications should be described. Do not repeat the details of established methods.
6.15. Results and Discussion
Results should be clear and concise. The results should summarize (scientific) findings rather than providing data in great detail. Please highlight differences between your results or findings and the previous publications by other researchers. The discussion should explore the significance of the results of the work, not repeat them. A combined Results and Discussion section is often appropriate. Avoid extensive citations and discussion of published literature.
In discussion, it is the most important section of your article. Here you get the chance to sell your data. Make the discussion corresponding to the results, but do not reiterate the results. Often should begin with a brief summary of the main scientific findings (not experimental results).
The following components should be covered in discussion: How do your results relate to the original question or objectives outlined in the Introduction section (what/how)? Do you provide interpretation scientifically for each of your results or findings presented (why)? Are your results consistent with what other investigators have reported (what else)? Or are there any differences?
Conclusions should answer the objectives of the research. Tells how your work advances the field from the present state of knowledge. Without clear Conclusions, reviewers and readers will find it difficult to judge the work, and whether or not it merits publication in the journal. Do not repeat the Abstract, or just list experimental results. Provide a clear scientific justification for your work, and indicate possible applications and extensions. You should also suggest future experiments and/or point out those that are underway.
Cite the main scientific publications on which your work is based. Cite only items that you have read. Do not inflate the manuscript with too many references. Avoid excessive self‐citations. Avoid excessive citations of publications from the same region. Check each reference against the original source (authors name, volume, issue, year, DOI Number). Please use Reference Manager Applications like End Note, Mendeley, Zotero, etc. Use other published articles in the same journal as models.
All publications cited in the text should be included as a list of references. References are sequentially numbered as they appear in the text. Reference numbers are indicated in square brackets. Please ensure that every reference cited in the text is also present in the reference list (and vice versa). Any references cited in the abstract must be given in full. Unpublished results and personal communications are not recommended in the reference list, but may be mentioned in the text. If these references are included in the reference list they should follow the standard reference style of the journal and should include a substitution of the publication date with either “Unpublished results” or “Personal communication”. Citation of a reference as 'in press' implies that the item has been accepted for publication.
As a minimum, the full URL should be given and the date when the reference was last accessed. Any further information, if known (DOI, author names, dates, a reference to a source publication, etc.), should also be given. Web references can be listed separately (e.g., after the reference list) under a different heading if desired, or can be included in the reference list.
Please ensure that the words 'this issue' are added to any references in the list (and any citations in the text) to other articles in the same Special Issue.
This journal has to follow standard templates available in key reference management packages EndNote (http://www.endnote.com/support/enstyles.asp), Mendeley (http://www.mendeley.com), or Reference Manager (http://refman.com/support/rmstyles.asp). Using plug-ins to word processing packages, authors only need to select the appropriate journal template when preparing their article and the list of references and citations to these will be formatted according to the journal style, which is described below.
Recommendations for references are:
- Include ALL authors. et al., for multiple authors is not acceptable.
- When referencing in the body of text, use 11pt Arial in square brackets .
- Types of references are as follows:
For a Book, see 
For a Journal Article, see 
For a Magazine Article, see 
For a Proceedings Paper, see 
For a Technical Report, see 
For a Dissertation or Thesis, see 
For an Internet Reference (not preferable), see 
When preparing your reference list, the following should be avoided:
- References not cited in the text.
- Excessively referencing your work.
- Insufficiently referencing the work of others.
It is also preferable when Authors give DOI number of each reference list in bracket , but it is optional for Authors.
Examples of guideline for preparing references list is described in the last section of this author guidelines.
1 Engelmore, R., Morgan, A. eds. (1986). Blackboard Systems. Reading, Mass.: Addison- Wesley. ← Book
2 Robinson, A.L. (1980). New Ways to Make Microcircuits Smaller. Science, 208: 1019-1026. ← Journal
3 Bhavsar, D.S., Saraf, K.B. (2002). Morphology of PbI2 Crystals Grown by Gel Method. Crystal Research and Technology, 37: 51–55 ←Journal
4 Hasling, D.W., Clancey, W.J., Rennels, G.R. (1983). Strategic Explanations in Consultation. The International Journal of Man-Machine Studies, 20(1): 3-19. ←Journal
5 Clancey, W.J. (1983). Communication, Simulation, and Intelligent Agents: Implications of Personal Intelligent Machines for Medical Education. In Proceedings of the Eighth International Joint Conference on Artificial Intelligence, 556-560. Menlo Park, Calif.: International Joint Conferences on Artificial Intelligence, Inc. ←Conferences
6 Rice, J. (1986). Polygon: A System for Parallel Problem Solving, Technical Report, KSL-86-19, Dept. of Computer Science, Stanford Univ. ←Report
7 Clancey, W.J. (1979). Transfer of Rule-Based Expertise through a Tutorial Dialogue. Ph.D. Dissertation, Department of Computer Science, Stanford University. ←Thesis
8 Ivey, K.C. (2 September 1996). Citing Internet sources URL http://www.eei- alex.com/eye/utw/96aug.html. ←Website