Design of Student and Course Learning Outcomes Measurement

Authors

  • Hans Kristianto Parahyangan Catholic University http://orcid.org/0000-0003-4747-4361
  • Susiana Prasetyo Parahyangan Catholic University
  • Ratna Frida Susanti Parahyangan Catholic University
  • Mariskha Tri Adithia Parahyangan Catholic University

DOI:

https://doi.org/10.23887/jpi-undiksha.v10i1.29061

Keywords:

Learning Outcome, Outcome Based Education, Outcome Measurement

Abstract

Measurement of the outcomes becomes a vital part in OBE system to ensure the attainment of each outcome. In Indonesia, OBE was adopted in 2015 for higher education level. However, the changes were not accompanied with clear method to measure the outcomes, which became the urgency of this research. In this study, a preliminary method to measure student learning outcomes (SLO) and course learning outcomes (CLO) was presented. The measurement of SLO and CLO attainment was started by SLO mapping to courses, which usually had been done at curriculum design. Based on the mapping, formulation of CLO with a set of direct assessment was planned at the start of each course. After the teaching learning activities, a series of calculation was designed to obtain the attainment of SLO and CLO for each student, course, and whole study program. In the same time the final mark for GPA calculation of each student could also be obtained. The designed method could play an essential part in teaching-learning quality assurance and curriculum continuous improvement, which is aligned with both international and national accreditation criteria and standards. Furthermore, this study could provide insight for other study program in SLO and CLO attainment measurement.

Author Biographies

Hans Kristianto, Parahyangan Catholic University

Department of Chemical Engineering, Faculty of Industrial Technology

Susiana Prasetyo, Parahyangan Catholic University

Department of Chemical Engineering, Faculty of Industrial Technology

Ratna Frida Susanti, Parahyangan Catholic University

Department of Chemical Engineering, Faculty of Industrial Technology

Mariskha Tri Adithia, Parahyangan Catholic University

Department of Informatics, Faculty of Information Technology and Sciences

References

BAN-PT. (2019). Panduan untuk Mempersiapkan Evaluasi Diri Akreditasi 4.0. Jakarta.

Biggs, J. (1996). Enhancing teaching through constructive alignment. Higher Education, 32, 347-364. https://doi.org/10.1007/BF00138871.

Biggs, J., & Tang, C. (2011). Teaching for Quality Learning at University (4th ed.). McGrawHill.

Caspersen, J., Smeby, J. C., & Olaf Aamodt, P. (2017). Measuring learning outcomes. European Journal of Education, 52(1), 20-30. https://doi.org/10.1111/ejed.12205.

Douglass, J. A., Thomson, G., & Zhao, C.-M. (2012). The learning outcomes race: the value of self-reported gains in large research universities. Higher Education, 64 (3), 317–335. https://doi.org/10.1007/s10734-011-9496-x.

Dyers, J. H., Gregersen, H., & Christensen, C. M. (2011). Innovators DNA. https://hbr.org/2009/12/the-innovators-dna.

Effendi, H., & Hendriyani, Y. (2019). The Conceptual and Hypothetical Model of Interactive Blended Problem Based Learning. Jurnal Pendidikan Indonesia, 8(2), 285-292. http://dx.doi.org/10.23887/jpi-undiksha.v8i2.24162.

Fletcher, A. J., Sharif, A. W. A., & Haw, M. D. (2017). Using the perceptions of chemical engineering students and graduates to develop employability skills. Education for Chemical Engineers, 18, 11-25. https://doi.org/10.1016/j.ece.2016.07.001.

Garry, B. (2015). Developing a Sustainable ABET Continuous Improvement Plan. Paper presented at the 2015 ASEE Zone III Conference.

Junaidi, A., Wulandari, D., Arifin, S., Soetanto, H., Kusumawardani, S. S., Wastutiningsih, S. P., Utama, M. S., Cahyono, E., Hertono, G. F., Syam, N. M., WY, H. J., Putra, P. H., Wijayanti, C., & Jobih. (2020). Panduan Penyusunan Kurikulum Pendidikan Tinggi di Era Industri 4.0 untuk Mendukung Merdeka Belajar-Kampus Merdeka. Direktorat Jenderal Pendidikan Tinggi Kementerian Pendidikan dan Kebudayaan.

Kasilingam, G., Ramalingam, M., & Chinnavan, E. (2014). Assessment of learning domains to improve student’s learning in higher education. Journal of Young Pharmacists, 6(4), 27-33.

Keshavarz, M. (2011). Measuring Course Learning Outcomes. Journal of Learning Design, 4(4), 1-9. https://eric.ed.gov/?id=EJ963323.

Kondo, A. E., & Fair, J. D. (2017). Insight into the Chemistry Skills Gap: The Duality between Expected and Desired Skills. Journal of Chemical Education, 94(3), 304-310. https://doi.org/10.1021/acs.jchemed.6b00566.

Krathwohl, D. R. (2002). A revision of Bloom’s Taxonomy: An overview. Theory into Practice, 41(4), 212–218. https://doi.org/10.1207/s15430421tip4104_2.

Makarim, N. A. (2020). Peraturan Menteri Pendidikan dan Kebudayaan no 3 tahun 2020 tentang Standard Nasional Pendidikan Tinggi. Kementerian Pendidikan dan Kebudayaan.

Mohamed, A., Abd.Aziz, A., Ahlan, A. R., Zakaria, S., & Masodi, M. (2008). Outcome Based Education Performance Measurement: A Rasch-based Longitudinal Assessment Model to measure Information Management Courses LO’s WSEAS Transactions on Information Science and Applications, 5(3), 292-299. https://doi.org/10.5555/1467006.1467017.

Mohamed, Z., Taib, M. Y., & Reza, M. S. (2010). Assessment Method for Course Outcome and Program Outcome In Outcome Based Education (OBE). Paper presented at the Malaysian Technical Universities Conference on Engineering and Technology, Malaysia.

Mustaffa, N. A., Zulkifliand, M., & Murat, R. I. Z. (2019). Measuring Course Learning Outcome for Large Class of Introductory Statistics Course. International Journal of Innovative Technology and Exploring Engineering, 8, 382-388.

Nasir, M. (2015). Peraturan Menteri Riset, Teknologi, dan Pendidikan Tinggi no 44 tentang Standard Nasional Pendidikan Tinggi. Jakarta: Kementerian Riset Teknologi dan Pendidikan Tinggi.

Nurwardani, P., Nugroho, S. W., Mulyono, E., Arifin, S., Djajanto, L., Soetanto, H., Kusumawardani, S. S., Wastutiningsih, S. P., Utama, M. S., Cahyono, E., Priyautama, F., Afriyudianto, Oscar, R., Prioningsih, Y., & Furkan, N. (2016). Panduan Penyusunan Kurikulum Pendidikan Tinggi. Direktorat Jenderal Pembelajaran dan Kemahasiswaan, Kementerian Riset Teknologi dan Pendidikan Tinggi.

Nurwardani, P., Nugroho, S. W., Mulyono, E., Arifin, S., Djajanto, L., Soetanto, H., Kusumawardani, S. S., Wastutiningsih, S. P., Utama, M. S., Cahyono, E., Priyautama, F., Afriyudianto, Oscar, R., Prioningsih, Y., & Furkan, N. (2018). Panduan Penyusunan Kurikulum Pendidikan Tinggi di Era Industri 4.0. Direktorat Jenderal Pembelajaran dan Kemahasiswaan, Kementerian Riset Teknologi dan Pendidikan Tinggi.

Rahman, N. A., & Abdullah, S. R. S. (2013). Assessment Tool of Course Learning Outcomes for Mechanical Design of Process Equipment. Procedia Social and Behavioral Sciences, 102, 116-121. https://doi.org/10.1016/j.sbspro.2013.10.721.

Rajak, A., Shrivastava, A. K., & Tripathi, A. K. (2019). An Approach to Evaluate Program Outcomes and Program Educational Objectives through Direct and Indirect Assessment Tools. International Journal of Emerging Technologies in Learning, 14(23), 85-97. https://www.learntechlib.org/p/217241/.

Santoso, M., Putra, A., Muhidong, J., Sailah, I., Mursid, S., Rifandi, A., Susetiawan, & Endrotomo. (2015). Surat Keterangan Pendamping Ijazah. Direktorat Jenderal Pembelajaran dan Kemahasiswaan, Kementerian Riset Teknologi dan Pendidikan Tinggi.

Saunders-Smits, G., & Graaff, E. d. (2012). Assessment of curriculum quality through alumni research. European Journal of Engineering Education, 37(2), 133-142. https://doi.org/10.1080/03043797.2012.665847.

Shafi, A., Saeed, S., Bamarouf, Y. A., Iqbal, S. Z., Min-Allah, N., & Alqahtani, M. A. (2019). Student Outcomes Assessment Methodology for ABET Accreditation: A Case Study of Computer Science and Computer Information Systems Programs. IEEE Access, 7, 13653-13667. https://ieeexplore.ieee.org/abstract/document/8620683.

Tshai, K. Y., Ho, J. H., Yap, E. H., & Ng, H. K. (2014). Outcome-based Education – The Assessment of Programme Educational Objectives for an Engineering Undergraduate Degree. Engineering Education, 9(1), 74-85. https://doi.org/10.11120/ened.2014.00020.

Widyartono, D., Dawud, Ghazali, A. S., & Harsiati, T. (2017). Cognitive, Psychomotor, and Affective Domain in Instruction on Writing Papers At University. International Journal of Social Science Humanity, 4(11), 4144-4148.

Zlatkin-Troitschanskaia, O., Shavelson, R. J., & Kuhn, C. (2015). The international state of research on measurement of competency in higher education. Studies in Higher Education, 40(3), 393–411. https://doi.org/10.1080/03075079.2015.1004241.

Downloads

Published

2021-03-10

Issue

Section

Articles